Verex MONITOR AFx Podręcznik Użytkownika Pobierz pdf (Strona 267)

500-9041 v4.1

Welcome Report Control Admin Sys Config

Tech-Ref

261

Do I Need an LCD Keypad?: Setting up a new

system/panel does

not

require an LCD keypad to be

installed. (You only need to know the serial number of

each main panel and expansion module--look for a

small hand-written label on the back of each circuit

board.) Transferring settings from an Existing Panel:

In this case, you

will

need an LCD keypad to view (or

set) the "Panel Code" (

S001:5

) and "Third-Party

Password" (

S005:1

Note:

The "Panel Code" must be

set to a non-zero value.

This section assumes that your system

devices (panels, expansion modules,

doors, and sensors) have already been

installed, or that someone else is installing

them.

Note:

If you do require details on physical

installation of a system components, refer to the

MONITOR AFx Commissioning Reference Guide,

in conjunction with the installation instructions

provided with each physical device.

If your MONITOR AFx Director

software

has not been installed yet,

if you are

upgrading from an earlier version of

software, refer to "PC Issues and Software

Installation".

The provided 'activation key' needs to be

plugged onto the server (or only) PC. (

≥

V4:

USB connector;

≤

V3.3.2:

Parallel/

printer port;

V3.3.3:

Either).

The activation key provides 90 days of operation

with standard features. For additional features,

client-server operation, or extended duration, you

must run the license-manager program.

For

details, refer to "Software Activation and Licensing".

Note:

For a

client-server

installation where you'll be

working from a separate client PC, you'll also need to

identify this PC (and other client PCs) to the server.

For details, refer to "Client / Server Setup (Allowable

Client List)".

If you wish to transfer settings from a

MONITOR AFx system main panel that

was programmed through a system LCD

keypad, refer to "Importing Settings from

an Existing MONITOR AFx Director

System Panel", to follow / below.

For each main panel, and expansion /

application module (POD) in the system,

you will need to know the device's serial

number so it can be correctly identified to

the software.

Tip:

The serial number for each device can

typically be found on a hand-written label on the

device's circuit board.

You must be aware of how the facility is to

be divided into 'Areas', if applicable. In

general, this will typically pertain to

departmental divisions, or any other major

divisions where different monitoring

characteristics are to be in effect, and/or

where a different set of users are to have

access.

Note:

If you need more information on this, find

out from the installation co-ordinator, building

manager, or other contact at the site.

For basic testing of access-control

functions, you will need at least one

access card / token with a known "ID"

number (and optional 'PIN' number).

Before You Begin (Form-by-Form Data Entry)

1 2 ... 262 263 264 265 266 267 268 269 270 271 272 ... 323 324

Komentarze do niniejszej Instrukcji

Brak uwag

Verex MONITOR AFx Podręcznik Użytkownika Strona 267

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Verex MONITOR AFx